How To Use A PTO-driven Post Hole Digger?

(Last Updated On: July 13, 2020)

If you dig a post hole with a PTO driven post hole digger, it can be safe and easy to follow, especially if you follow the rules. One of the most important things will be to check the manual of instructions, and if you don’t know how to handle it all, you can call an expert, and they will make work easy. Ensure that you mark the area where the digging is going to take place and then mark your utilities to know where all the attention has to be focused. When you have checked out the place, you have to mark the areas where they hold is to be dug. In this buying guide, we will discuss how to use a PTO-driven post hole digger.

Safety & Preparation

The first step is to check out the manual instructions and start digging the holes in the desired area. It would help if you determined an area that is safe for digging, and when you have done that, you have to examine the area and make holes in each of the locations. It is also essential to know what type of soil is available in the area, and whether it is hard or sticky, you can take care of it. You have to use your tractor with the post hole digger and attach the auger as well. There are many post hole diggers, and if you need to work with it properly, hand it in a vertical position.

Dig In

You need to lower the auger in one position; holes won’t be of the same diameter. Once you raise the auger and contact the ground, you can move the tractor forward with caution. You also have to set the speed of the engine and engage it with a PTO. Raising the PTO speed is one requirement, while the engine will carry out the operation with ease. The engine’s maximum speed is 540 RPM, and it will pierce the level of ground quite quickly. The auger will penetrate the ground, and dirt will start coming out of the hole. You can continue to drill downwards and lower the 3-point hitch into a new location altogether.

When you lift the auger, in the end, it will release excess levels of soil from the hard and sturdy surface. You have to pay attention to the auger’s position and keep moving the tractor back and forth. The user has to repeat this process each time they start reaching the depth of the soil. Sometimes it happens that you may hit the root while digging a hole and changing the tractor’s direction at this point will reverse the auger to break free. Once the hole has been dug into the desired depth, you can lower and raise the auger and remove loose and hard dirt. When your task is done, you have to extract the auger from the hole and disengage the PTO to continue marking the next location.

 

 

Recommended Readings (Next Best Info)

Leave a Reply

Your email address will not be published. Required fields are marked *